SC2000 Series Vision Sensor User Manual
49
7.4.18 Logic Tool
This tool allows you to select different logical operation types and execute logic operation.
Select AND, OR, NOT, NAND or NOR as Logical Operation Type, and click to link data source
or enter data directly. You can also click to add multiple data.
Note
If there is logic module in the solution, you can go to Solution → Others → Solution Result to link
the result of logic tool to the solution.
Figure 7-31 Logic Tool
7.5 Communication Settings
The communication settings determine how the device outputs data, and you can go to Solution
→ Output to select different communication tools according to actual demands.
7.5.1 UDP
In basic parameter interface, set output information as Input Variable, and enter Local IP, Local
Port, Target IP and Target Port according to actual solution demands.
Note
Input Variable currently supports format result data only.
In display interface, enable Display Text to set text's color, front size, transparency, position X, and
position Y.
To Next Page
Loading...
