HikRobot SC2000 Series - Chapter 5 Installation; 5.2 Install Device

SC2000 Series Vision Sensor User Manual
13
Chapter 5 Installation
5.1 Installation Preparation
You need to prepare following accessories before installation.
Table 5-1 Accessories
No.
Name
Quantity
Description
1
17-Pin Cable
1
It refers to the supplied 17-pin cable that is
included in the package.
2
Power Adapter or
Switch Power Supply
1
You should select suitable power adapter or
switch power supply according to the device
power supply and consumption. You need to
purchase separately.
3
Lens Cap
1
It refers to the supplied lens cap. You can
also use polarization lens cap that needs to
be purchased separately.
4
Light Source
1
It refers to the supplied white light source.
You can also use red or blue light source that
needs to be purchased separately.
5
M4 Screw
4
It refers to the supplied M4 screw that is
used to fix the device to installation position.
5.2 Install Device
Before You Start
● Make sure the device in the package is in good condition and all the assembly parts are
included.
● Make sure all the related equipment is power-off during the installation.
Steps
1. Use M4 screw to fix the device to the installation position.
2. Connect the device to a power adapter or switch power supply via 17-pin cable.
3. Connect the device to a switch via network cable.