Control Panel User Manual
106
Uploading Mode Configuration
Purpose:
You can select to send Zone report, alarm report and configure the uploading
mode of the selected center group in this section.
Steps:
1. Enter the uploading mode configuration page.
Remote Configuration->Uploading Mode Settings
2. Click the drop down menu to select a center group.
3. Check the Enable checkbox to enable the configuration
4. Check the checkbox to select the required Zone for sending the Zone report
for the Zones without Zone report.
At most 6 center groups can be inter-combined to send the alarm
report.
5. Check the checkbox to select the type of non-Zone alarm report.
To Next Page
Loading...
