HIKVISION DS-19A08-F/Kx - Page 134

Control Panel User Manual
134
Disconnection
4
Receive the Hand-shack
Sound
8
Alarm Connector On-hook
LED keypad Camera indicator under Status Mode:
No.
Description
No.
Description
1
AC Power off
5
Keypad Off-line
2
Battery Low Voltage
6
Network Cable Off-line
3
Control Panel Tamper-proof
On
7
No SIM Card
4
ADSL Cable Off-line
8
Reserved
Q: What is the meaning of LED keypad alert sound?
A: The meaning of LED keypad alert sound is as follows:
No.
Keypad Alert Sound
Description
1
1 Sound
Keypad Prompt, Error Operating
Prompt
2
2 Sound
Correctly answered, report uploading
succeeded
3
5 Sound
Incorrectly answered, report uploading
failed in 60s
4
Last for 2s
Error Prompt
5
Intermittent Slow Sound,
Continuously
Enter/Exit Delay
6
Intermittent Rapid Sound,
Continuously
Enter/Exit Delay, 10s Left
7
Rapid Beep
Sensor Alarm, Keypad not logged in
8
3 Long 2 Short
Keypad Tamper-proof On
Q: How to remove alarm memory?
A: There are two situations of removing alarm memory as shown below: