Control Panel User Manual
141
1. Center uploading mode supports at most 6 center groups, each center group
divides in main channel and 3 backup channels;
2. If the center group is enabled. Enable the center group before the use.
3. For example: The control panel needs to upload report to network alarm
center 1 and dialing alarm center1 and network alarm center 1 needs to
upload report to network alarm center 2 when it fails to upload it. The
configurations are as follows:
1) Enable Group1 and Group2;
2) In the uploading mode configuration list, select N1 in center group 1 main
channel, select N2 in backup channel 1, select T1 in Center group2 main
channel.
3) Click Apply.
If the client is not opened, the user can realize communication with alarm
center by programming with keypad. For detailed operations please refer to
program command 611~634.
Q: Why cannot it upload report and control after WIFI is enabled?
A: The follow situations may lead to WIWI connection failure:
1) No SIM Card or poor contact;
2) 3G module antenna is not normally connected or with poor signal;
3) WIFI parameter setting is incorrect;
4) SIM Card has no enough tariffs.
To Next Page
Loading...
Need help?
General
