Control Panel User Manual
56
{7} Neywork Exception
{8} Wireless Network Exception
{9} End the command.
If the fault detection is disabled, the control panel will not detect or report this
sort of fault.
Keypad Fault Display Configuration
To configure the system fault display, please refer to the command below.
565 1 1 1 1 1 1 1 #
1 2 4
6
3
5
7 8
9
{1} Keypad fault display configuration programming address: 565
{2} Ac Power Down
{3} Low Battery
{4} Control Panel Tampering Alarm
{5} Phone Line Disconnection
{6} Main keypad Disconnection
{7} Neywork Exception
{8} GPRS Exception
{9} End the command.
After successfully operating once, you can continuously do configuration with
the command of {Project} + {Partition No.} + {Configuration} + {#}.
To Next Page
Loading...
