HIKVISION DS-19A08-F/Kx - Page 62

Control Panel User Manual
62
Command
Command
Description
Command
Command
Description
Programming Address
Programming
Address
629
Center Group 5 Zone
Alarm Report
Programming Address
633
Center Group 6
Zone Alarm Report
Programming
Address
{2} Delete/Add
{3} Zone No.
{4} End the command.
The operation of adding/ deleting is just for current center group sending/not
sending report, and will not impact other center groups.
Center Group Non-zone Alarm Report Configuration
To configure the non-zone alarm report of the center group, please refer to the
command below.
614 1 1 1 1 1 1 1 1 1 1 #
1
4 5 7
8
9
2 3 6
10
11
12
{1} Center Group Non-zone Alarm Report Programming Address: 614,
618, 622, 626, 630and 634.
Command
Command
Description
Command
Command
Description
614
Center Group1
Non-zone Alarm
Report Programming
Address
618
Center Group
2Non-zone Alarm
Report Programming
Address
622
Center Group3
626
Center Group 4