Control Panel User Manual
71
When you set the start and end time as non-zero, end time must be
greater than start time in every time bucket.
When you set the start and end time as non-zero, the start time
must be 5min greater than the end time of the previous time
bucket.
When you set the start and end time as non-zero, if the time bucket
is overlapped with the latter ones, or the difference between them
is less than 5min, all the settings of the latter ones will be cleared.
{13} Three types of Arming/Disarming.
Real-time
Arming/Dis
arming
{14} End the command.
Copying Weekly Schedule
To copy the settings of the day (n) to another day (l) of the week in partition
(m), please refer to the command below.
{1} Copy Weekly Schedule Command Address: 692.
{2} Partition (m) Number. 01~08 indicate partitions No.1~No.8.
{3} It indicates the value range of the day (n).
To Next Page
Loading...
