1. Select HSBLC by setting the OK button to left/right, and press OK to enter the
edit interface.
2. Move the cursor to SELECT and select the area by pressing the OK button to
left/right. Four areas are selectable.
3. Set the display as ON to display the HLC area.
4. Press OK button to enter the position/size edit interface.
5. Press the OK button up/down/left/right to define the position/size.
6. Press OK button to confirm the configuration.
LEVEL
It is adjustable from 0 to 100. If the brightness is higher than the level you set,
the HLC will take effect.
MODE
ALL DAY refers to the HSBLC works all day. Night refers to the HLC only works in
night.
BLACK MASK
ON and OFF are selectable. Only when the Black Mask is set to ON, the HSBLCS
configuration will take effect. If you the set black mask to OFF, the HLCS function
is disabled.
DEFAULT
Selecting DEFAULT will restore all the configured settings to the default.
To Next Page
Loading...
Need help?
General
