HIKVISION DS-2TD2637T-7/P - Page 5

Safety Instrucon
These instrucons are intended to ensure that user can use the product correctly to avoid danger
or property loss.
Laws and Regulaons
●
In the use of the product, you must be in strict compliance with the electrical safety regulaons
of the naon and region.
Transportaon
●
Keep the device in original or similar packaging while
transporng it.
●
Keep all wrappers
aer unpacking them for future use. In case of any failure occurred, you need
to return the device to the factory with the original wrapper. Transportaon without the original
wrapper may result in damage on the device and the company shall not take any
responsibilies.
●
DO NOT drop the product or subject it to physical shock. Keep the device away from magnec
interference.
Power Supply
●
Check the input voltage before powering on the device to avoid damage.
●
CAUTION: If the fuse of the device can be replaced, replace it only with the same model to
reduce the risk of
re or electric shock.
●
If a fuse is connected to the neutral wire and a double pole/neutral fusing occurs, parts of the
device that remain energized might represent a hazard during servicing
aer operaon of the
fuse.
●
If the device uses a 3-prong power supply plug, it must be connected to an earthed mains
socket-outlet properly.
●
Do not touch the bare components (such as the metal contacts of the inlets) and wait for at least
5 minutes, since electricity may
sll exist aer the device is powered o.
●
For the permanently connected device without a disconnect equipment, a readily accessible
disconnect equipment shall be incorporated into the electrical installaon of the connected
building.
●
For the permanently connected device without an overcurrent
protecon equipment, an
overcurrent
protecon equipment shall be incorporated into the electrical installaon of the
connected building. The specicaons of the overcurrent protecon equipment shall not exceed
that of the building.
●
For the permanently connected device without an all-pole mains switch, an all-pole mains switch
shall be incorporated into the electrical
installaon of the connected building.
●
If the device is powered by terminals connected to the power cord, ensure correct voltage and
wiring of the terminals for connecon to mains supply.
Thermal Opcal Bi-spectrum Network Camera User Manual
iv