HIKVISION DS-2TD2637T-7/P User Manual

●
Please purchase the charger by yourself. Input voltage should meet the Limited Power Source
(12 VDC, 24 VAC, or PoE(802.3af)) according to the IEC62368 standard. Please refer to technical
specicaons for detailed informaon.
●
Make sure the plug is properly connected to the power socket.
●
The socket-outlet shall be installed near the equipment and shall be easily accessible.
●
DO NOT connect mulple devices to one power adapter, to avoid over-heang or re hazards
caused by overload.
●
DO NOT touch the bare metal contacts of the inlets
aer the circuit breaker is turned o.
Electricity sll exists.
●
+
idenes the posive terminal(s) of equipment which is used with, or generates direct current.
-
idenes the negave terminal(s) of equipment which is used with, or generates direct current.
Baery
●
Risk of explosion if the baery is replaced by an incorrect type. Dispose of used baeries
according to the instrucons.
●
The built-in
baery cannot be dismantled. Please contact the manufacture for repair if
necessary.
●
For long-term storage of the
baery, make sure it is fully charged every half year to ensure the
baery quality. Otherwise, damage may occur.
●
This equipment is not suitable for use in
locaons where children are likely to be present.
●
Improper replacement of the baery with an incorrect type may defeat a safeguard (for
example, in the case of some lithium baery types).
●
DO NOT dispose of the
baery into re or a hot oven, or mechanically crush or cut the baery,
which may result in an explosion.
●
DO NOT leave the
baery in an extremely high temperature surrounding environment, which
may result in an explosion or the leakage of ammable liquid or gas.
●
DO NOT subject the
baery to extremely low air pressure, which may result in an explosion or
the leakage of ammable liquid or gas.
Installaon
●
This device is suitable for use above 2 m only.
●
Install the device according to the
instrucons in Quick Start Guide. To prevent injury, this device
must be securely aached to the installaon surface in accordance with the installaon
instrucons.
●
Never place the device in an unstable locaon. The device may fall, causing serious personal
injury or death.
●
The
addional force shall be equal to three mes the weight of the device but not less than 50
N. The device and its associated mounng means shall remain secure during the installaon.
Aer
the installaon, the device, including any associated mounng plate, shall not be damaged.
●
Never place the equipment in an unstable locaon. The equipment may fall, causing serious
personal injury or death.
●
This equipment is for use only with corresponding brackets. Use with other (carts, stands, or
carriers) may result in instability causing injury.
Thermal Opcal Bi-spectrum Network Camera User Manual
v

HIKVISION DS-2TD2637T-7/P Specifications

General

Brand	HIKVISION
Model	DS-2TD2637T-7/P
Category	Security Camera
Language	English