HIKVISION DS-3WF03C-D - 2.2 Restore to the Factory Settings

User Manual of
other devices, or leave it unconnected
5. Mount the DS-
3WF03C
2.2
Restore to the Factory
In some cases, uses can restore the device to the factory settings by the following way in
the figure
. Push the reset button for 5~10 seconds until all LED
will restore to the factory setting. During this process, the
will be connected and disconnected twice.
For default, all the factory settings are shown in the following
Table
Items
IP address
User name
Password
Output power
Encryption
Network mode
User Manual of
DS-3WF03C-D
Outdoor Video Wireless Network
13
other devices, or leave it unconnected
3WF03C
-D
securely to the pole by locking the strap tightly.
Restore to the Factory
Settings
In some cases, uses can restore the device to the factory settings by the following way in
. Push the reset button for 5~10 seconds until all LED
s are
on. Th
will restore to the factory setting. During this process, the
DS-3
WF03C
will be connected and disconnected twice.
Figure 2-2 Restore to the factory settings
For default, all the factory settings are shown in the following
table.
Table
2-1 Main parameters at the factory settings
Default Settings
192.168.1.35/192.168.1.36
admin
admin
High
WPA->WPA2->CCMP-
>Password:1234567890abc
Bridge
Outdoor Video Wireless Network
Bridge
securely to the pole by locking the strap tightly.
In some cases, uses can restore the device to the factory settings by the following way in
on. Th
en the device
WF03C
-D’s RJ45 ports
>Password:1234567890abc