HIKVISION DS-7100NI-Q1/P Series - Page 37

Figure 5-7 IP Camera Management Interface
2. Select a desired network camera.
3. Click to add the camera.
Note
If the camera is inacve, the device will acvate it automacally with the password you have set
during device acvaon.
Add Network Camera Manually
Before You Start
●
Ensure your network camera is on the same network segment with that of your video recorder.
●
Ensure the network
connecon is valid and correct.
●
Ensure the network camera is acvated.
Steps
1. Go to
Conguraon → Camera → IP Camera .
2. Click in Added Device List.
3. Set network camera parameters, including IP address, protocol, management port, etc.
4.
Oponal: Enable Use Camera Acvaon Password to use the device password to add network
camera(s).
5.
Oponal: Click Add More to add another network camera.
6. Click Add.
Network Video Recorder User Manual
23