HIKVISION DS-7100NI-Q1/P Series - Event

5.3.3 Event
Moon Detecon
Moon detecon enables the video recorder to detect the moving objects in the monitored area
and trigger alarms.
Steps
1. Go to Conguraon → Camera → Event → Moon Detecon .
Figure 5-10 Moon Detecon
2. Select a camera.
3. Turn on Enable.
4. Set the
moon detecon area.
-
Click Draw Area or Clear to draw or clear areas. The rst area is set as full screen by default.
-
Click Full Screen to set the
moon detecon area as full screen. You can drag on the preview
window to draw
moon detecon areas.
5. Adjust Sensivity. Sensivity allows you to calibrate how easily movement could trigger the
alarm. A higher value results in the more readily to triggers moon detecon.
6. Oponal: Set Target Detecon as Human or Vehicle to discard alarms which are not triggered
by human body or vehicle. Only certain camera models support this funcon.
Note
This funcon is only available for certain models.
7. Set the arming schedule. Refer to Congure Arming Schedule for details.
8. Set the linkage
acons. Refer to Congure Alarm Linkage Acon for details.
9. Click Apply.
Network Video Recorder User Manual
27