HIKVISION DS-7100NI-Q1/P Series - Ntp; Log Server Settings

6.2.4 NTP
Your device can connect to a network me protocol (NTP) server to ensure that the system me is
accurate.
Steps
1. Go to
Conguraon → Network → General → NTP .
2. Turn on Enable.
3. Enter the parameters.
Interval
Time interval between two
me synchronizaon with NTP server.
NTP Server
IP address of the NTP server.
4. Click Apply.
6.2.5 Log Server
Sengs
Upload Logs to the Server
You can upload system logs to the server for backup.
Steps
1. Go to Conguraon → Network → General → Log Server Sengs .
Figure 6-7 Log Server Sengs
2. Turn on Enable
3. Set Upload Time Interval, Server IP Address, and Port.
4.
Oponal: Click Test to test if parameters are valid.
5. Click Apply.
Network Video Recorder User Manual
40