HIKVISION DS-7100NI-Q1/P Series - Ports (more Settings)

Figure 6-9 Two-Way Authencaon
2. Install the CA cercate in CA Cercate.
3. Click Create in Client Cercate, and follow the pop-up to create the cercate.
4. Click Download to download the cercate le to a desired locaon.
5. Upload the downloaded cercate le to the server, and the server will return the cercate
key.
6. Open the
cercate as a text le, and modify it by the cercate key as the server returned.
7. Install the modied cercate in Client Cercate.
8.
Oponal: Click Test to test if the connecon is valid.
9. Click Save.
6.2.6 Ports (More
Sengs)
Set dierent port types to enable relevant funcons as your desire.
Go to Conguraon → Network → General → More Sengs .
Alarm Host IP/Port
The device will send the alarm event or
excepon message to the alarm host when an alarm is
triggered. The remote alarm host must have the client management system (CMS) soware
installed.
Alarm Host IP refers to the IP address of the remote PC on which the CMS soware (e.g.,
iVMS-4200) is installed, and the Alarm Host Port (7200 by default) must be the same as the
alarm monitoring port
congured in the soware.
Server Port
For remote client soware access. Ranges from 2000 to 65535. The default value is 8000.
HTTP Port
Network Video Recorder User Manual
42