HIKVISION DS-7100NI-Q1/P Series - Page 62

3. Enter Network Segment.
Figure 6-14 Enter Network Segment
4. Click Add.
Add Network Camera Through Plug-and-Play
If an inacve network camera or third party ONVIF camera is connected to your network, the video
recorder may automacally detect and add the camera, or nofy you to manually add it.
Steps
1. Go to
Conguraon → Camera → Camera → IP Channel .
2. Click More.
3. Select Plug-and-Play.
4. Oponal: Enable Auto Add Network Camera. The video recorder would automacally detect
and add the
inacve network camera or third party ONVIF camera.
Figure 6-15 Auto Add Network Camera
Note
If you turn o Auto Add Network Camera, when an inacve network camera or third party
ONVIF camera is connected to your network, the video recorder would automacally detect it
and nofy you to add it.
Edit Network Camera
You can edit the IP address, protocol and other parameters of network cameras.
Steps
1. Go to Conguraon → Camera → Camera .
2. Click
of an added network camera.
Channel Port
If the connected device is an encoding device with mulple channels, you can choose the
channel to connect by
selecng the channel port No. in the drop-down list.
Network Video Recorder User Manual
48