HIKVISION DS-KH6350-WTE1 User Manual

Chapter 2 Acvaon
2.1 Acvate via iVMS-4200 Client Soware
You can only congure and operate the indoor staon aer creang a password for the device
acvaon.
Before You Start
Default parameters of indoor staon are as follows:
●
Default IP Address: 192.0.0.64.
●
Default Port No.: 8000.
●
Default User Name: admin.
Steps
1.
Run the client
soware, enter Device Management, check the Online Device area.
2.
Select an inacvated device and click the Acvate.
3.
Create a password, and
conrm the password.
Note
We highly recommend you to create a strong password of your own choosing (using a minimum
of 8 characters, including at least three kinds of following categories: upper case leers, lower
case leers, numbers, and special characters) in order to increase the security of your product.
And we recommend you change your password regularly, especially in the high security system,
changing the password monthly or weekly can beer protect your product.
4.
Click OK to acvate the device.
Network Indoor Staon Conguraon Guide
2

HIKVISION DS-KH6350-WTE1 Specifications

General

Color	Yes
Connectivity technology	Wired & Wireless
Number of displays supported	1
Maximum number of cameras supported	-
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	128 GB
Flash memory	32 MB
Internal memory	128 MB
Alarm input channels	8
Operating system installed	Embedded LINUX
Package weight	683 g
Outdoor unit included	No
Display diagonal	7 \
Touchscreen type	Capacitive
Display resolution	1024 x 600 pixels
Display technology	TFT
Product color	Black
Voice codecs	G.711a, G.711u
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet interface type	Fast Ethernet
Supported network protocols	TCP/IP, SIP, RTSP
Power consumption (typical)	8 W

Weight and Dimensions

Depth	21 mm
Width	175 mm
Height	113.5 mm
Weight	355 g