HIKVISION DS-KH6350-WTE1 User Manual

4.
Enter the required informaon.
Serial No.
Enter the device's serial No.. The serial No. is on the rear panel of the device (A xed-length
number with 9 digits).
IP Address
Enter the device's IP address.
Gateway
Enter the device's gateway.
Subnet Mask
Enter the device's subnet mask.
Password
Enter the device password, ranging from 8 to 16 characters in length.
No.
Enter the device No., ranging from 1 to 5.
5.
Click Save to enable the
sengs.
6.
Set SIP informaon.
Click
Congure Congure serial No., IP address, gateway, subnet mask, password and No. of
the device.
Click Delete Delete the SIP Number.
Click Clear Clear all SIP numbers.
Click Refresh Refresh SIP Informaon.
4.3.3 Network
Local Network Conguraon
Steps
1.
Click Local Network Conguraon to enter the conguring the local network parameters page.
Network Indoor Staon Conguraon Guide
60

HIKVISION DS-KH6350-WTE1 Specifications

General

Color	Yes
Connectivity technology	Wired & Wireless
Number of displays supported	1
Maximum number of cameras supported	-
Compatible memory cards	MicroSD (TransFlash)
Maximum memory card size	128 GB
Flash memory	32 MB
Internal memory	128 MB
Alarm input channels	8
Operating system installed	Embedded LINUX
Package weight	683 g
Outdoor unit included	No
Display diagonal	7 \
Touchscreen type	Capacitive
Display resolution	1024 x 600 pixels
Display technology	TFT
Product color	Black
Voice codecs	G.711a, G.711u
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet interface type	Fast Ethernet
Supported network protocols	TCP/IP, SIP, RTSP
Power consumption (typical)	8 W

Weight and Dimensions

Depth	21 mm
Width	175 mm
Height	113.5 mm
Weight	355 g