HIKVISION DS-TDSB00-EKT/POE/4M - Chapter 3 Radar Detection; Set Radar Mode

Chapter 3 Radar Detecon
Enter a short descripon of your concept here (oponal).
This is the start of your concept.
3.1 Set Radar Mode
Set radar mode according to the actual needs.
Steps
1.
Go to
Conguraon → System → System Sengs → Radar .
Figure 3-1 Set Radar Mode
2.
Select Radar Mode according to the actual needs.
Standby Mode
The radar is not
detecng.
Wakeup Mode
The radar is detecng.
3.
Oponal: Check Low Power Consumpon Mode and set Interval according to the actual needs.
If no human body is detected
aer the set Interval, the radar will automacally switch to
Standby Mode and detect according to the set Interval.
4.
Set the indicator mode.
-
Scheduled Mode: The indicator will be turned on/o according to the set Start Time and End
Time.
-
Manual Switch: Turn on/o the indicator manually.
5.
Click Save.
Fall Detecon Radar User Manual
5