HIKVISION DS-TDSB00-EKT/POE/4M - Connect to Platform; Connect to OTAP

5.4 Connect to Plaorm
5.4.1 Connect to OTAP
The device can be accessed to the maintenance plaorm via OTAP protocol, in order to search and
acquire device informaon.
Before You Start
Ensure the device can communicate with the
plaorm normally.
Steps
1.
Go to Conguraon → Network → Data Connecon → OTAP .
2.
Check Enable.
Figure 5-2 Connect to OTAP
3.
Select Address Type.
4.
Enter the server IP address/domain, port, and device ID.
Note
The device ID should be the same with the added one on the OTAP plaorm.
5.
Enter Key.
Note
Enter the same Key on the plaorm.
6.
Click Save.
What to do next
When the registraon status is online, you can add or manage the device via the plaorm
soware. Refer to its corresponding manual for details.
Fall Detecon Radar User Manual
11