HIKVISION DS-TDSB00-EKT/POE/4M - Set IP Address Filtering; Set Timeout Logout; Set Password Validity Period

3.
Click Save.
7.6 Set IP Address Filtering
You can set the IP addresses allowable and not allowable to access the device.
Steps
1.
Go to Conguraon → System → Security → Security Sengs .
2.
Check Enable IP Address Filtering.
3.
Set Filtering Mode.
Blocklist Mode
The added IP addresses are not allowed to access the device.
Allowlist Mode
The added IP addresses are allowed to access the device.
4.
Click Add, enter the IP address, and click OK.
Note
The IP address only refers to the IPv4 address.
5.
Oponal: Edit, delete, or clear the added IP addresses.
6.
Click Save.
7.7 Set Timeout Logout
You can improve network access security by seng meout logout.
Steps
1.
Go to Conguraon → System → Security → Security Service → Timeout Logout .
2.
Enable
meout logout for stac page.
3.
Set Max. Timeout.
4.
Click Save.
Result
When the page stac me exceeds the set me, the device will automacally log out.
7.8 Set Password Validity Period
You can improve network access security by seng password validity period.
Steps
1.
Go to Conguraon → System → Security → Security Service → Password Validity Period .
2.
Select Validity Type.
Fall Detecon Radar User Manual
19