HIKVISION DS-TDSB00-EKT/POE/4M - Set Detection Parameters

3.2 Set Detecon Parameters
Set radar detecon parameters according to the actual needs and installaon environment.
Steps
1.
Click Falling Monitoring.
Figure 3-2 Set Detecon Parameters
2.
View the radar informaon.
Radar Status
The current radar status. The radar can be normally used in normal status. If the radar is in
upgrading status, do not reboot the device.
Soware Version
The soware version of the radar.
3.
Set the radar detecon parameters.
Event Triggered Time
If the target falls and stands up within the set Event Triggered Time, the system will not
output fall alarm.
Sensivity Threshold of Human Body Detecon
The higher the value is, the less sensive the detecon will be. The default value is
recommended.
4.
Set
Detecon Area.
5.
Oponal: You can also do the following operaons.
Adjust the view scale.
Export Data Click Export Data, select the saving path, and click OK to export the
locaon informaon.
Fall Detecon Radar User Manual
6