HIKVISION DS-TDSB00-EKT/POE/4M - Set Wi-Fi; Set Wi-Fi AP

5.2 Set Wi-Fi
Set Wi-Fi parameters if you want to connect the device to the network via Wi-Fi.
Steps
1.
Go to Conguraon → Network → Network Parameters → Wi-Fi .
2.
Select Wi-Fi Mode as Wi-Fi.
3.
Click Search and select Wi-Fi to connect in the Wi-Fi list.
4.
Select Security Mode and
Encrypon Type according to the actual needs.
5.
Enter Key.
6.
Click Save.
7.
Oponal: If you want to edit the IP address connected to the Wi-Fi to make it convenient to
access to the device via the IP address of WLAN, set the IP address of WLAN.
1) Select IP Address Type as
Stac IP.
2) Enter IP Address, Subnet Mask, Route Addressetc.
3) Click Set.
8.
Oponal: Click Refresh to view the Wi-Fi connecon status.
5.3 Set Wi-Fi AP
The device can be set as a hotspot to share network to other devices.
Steps
1.
Go to Conguraon → Network → Network Parameters → Wi-Fi .
2.
Select Wi-Fi Mode as Wi-Fi Hotspot.
3.
Enable AP Broadcast or WLAN Hotspot.
AP Broadcast
Once enabled, other devices are able to detect the SSID of the device.
WLAN Hotspot
Enable it to share the device's internet
connecon. Other devices can access to internet via
joining the hotspot.
4.
Set Wi-Fi hotspot parameters.
1) Enter SSID (hotspot name).
2) Select Security Mode and
Encrypon Type.
3) Set Key.
5.
Check DHCP, and enter an IP address from the address pool that allows
automac obtaining.
Note
IP address and TCP/IP address have to be in dierent network segments.
6.
Oponal: Set DNS server address if you need to visit the device with domain name.
7.
Click Save.
Fall Detecon Radar User Manual
10