HIKVISION DS-TDSB00-EKT/POE/4M - Chapter 5 Network Configuration; Set IP Address

Chapter 5 Network Conguraon
5.1 Set IP Address
IP address must be properly congured before you operate the device over network. IPv4 and IPv6
are both supported. Both versions can be congured simultaneously without conicng to each
other.
Steps
1.
Go to
Conguraon → Network → Network Parameters → Network Interface .
Figure 5-1 Set IP Address
2.
Set network parameters.
NIC Type
Fall Detecon Radar User Manual
8