HIKVISION HWN-4108MH-8P - Page 80

3.
Turn on Enable.
4.
Set the detecon rules and detecon areas.
1) Select Arming Area.
2) Adjust Time Threshold and
Sensivity.
Sensivity
The size of the object that can trigger the alarm. The higher the value is, the more easily
the detecon alarm will be triggered. Its range is [1-100].
Time Threshold
Range [1s-10s], the threshold for the me of the object loitering in the region. When the
duraon of the object in the dened detecon area is longer than the set me, the alarm
will be triggered.
3) Oponal: Set Target Detecon as Human or Vehicle to discard alarms which are not triggered
by human body or vehicle.
Note
This funcon is only available for certain models.
4) Click Draw Area and draw a quadrilateral in the preview window by specifying four vertexes of
the detecon region.
5.
Set the arming schedule. Refer to
Congure Arming Schedule for details.
6.
Set the linkage acons. Refer to Congure Alarm Linkage Acon for details.
7.
Click Apply.
Region Entrance
Detecon
Region entrance detecon funcon detects people, vehicle or other objects which enter a pre-
dened
virtual region from the outside place, and some certain acons can be taken when the
alarm is triggered.
Steps
1.
Go to Conguraon → Event → Smart Event → Region Entrance .
2.
Select Camera to
congure.
3.
Check Enable Region Entrance Detecon.
4.
Check Save VCA Picture to save the captured pictures of VCA
detecon.
5.
Set the detecon rules and detecon areas.
1) Select Arming Area. Up to 4 arming areas are selectable.
2) Click Draw Area and draw a quadrilateral in the preview window by specifying four vertexes of
the
detecon region.
3) Adjust
Sensivity. Sensivity: Range [0-100]. The higher the value is, the more easily the
detecon alarm can be triggered.
6.
Set the arming schedule.
7.
Set the linkage
acons.
8.
Click Apply.
Network Video Recorder User Manual
67