HIKVISION HWN-4108MH-8P User Manual

6.5.6 Congure Alarm Linkage Acon
Congure Full Screen Monitoring
When an alarm is triggered, the local monitor displays in full screen the video image from the
alarming channel congured for full screen monitoring. And when the alarm is triggered
simultaneously in several channels, you must congure the auto-switch dwell me.
Steps
1.
Go to
Conguraon → System → Live View → General .
2.
Set the event output and dwell me.
Event Output
Select the output to show event video.
Full Screen Monitoring Dwell Time
Set the me in seconds to show alarm event image. If alarms are triggered simultaneously in
several channels, their full-screen images will be switched at an interval of 10 seconds
(default dwell
me).
3.
Go to Linkage Acon interface of the alarm detecon.
4.
Select Full Screen Monitoring alarm linkage acon.
5.
Select the channel(s) in Trigger Channel sengs you want to make full screen monitoring.
Note
Auto-switch will terminate once the alarm stops and back to the live view interface.
Congure Audio Warning
The audio warning enables the video recorder to trigger an audible beep when an alarm is
detected.
Steps
1.
Go to
Conguraon → System → Live View → General .
2.
Enable Audio Output and set Volume.
3.
Go to Linkage
Acon interface of the alarm detecon.
4.
Select Audio Warning alarm linkage acon.
Nofy
Surveillance Center
The video recorder can send an excepon or alarm signal to the remote alarm host when an event
occurs. The alarm host refers to the computer installed with client soware (e.g., iVMS-4200,
iVMS-5200).
Network Video Recorder User Manual
70

HIKVISION HWN-4108MH-8P Specifications

General

Brand	HIKVISION
Model	HWN-4108MH-8P
Category	Network Hardware
Language	English