HIKVISION HWN-4108MH-8P - Page 84

Steps
1.
Log into video recorder in web browser.
2.
Go to Conguraon → Network → Advanced Sengs → Other .
3.
Set Alarm Host IP and Alarm Host Port.
4.
In local menu, go to Linkage Acon interface of the alarm detecon.
5.
Select Nofy Surveillance Center.
Congure Email Linkage
The video recorder can send an email with alarm informaon to a user or users when an alarm is
detected.
Steps
1.
Switch to easy mode.
2.
Go to
Conguraon → System → Network → Email .
3.
Congure the Email sengs.
4.
Go to Linkage Acon interface of the alarm detecon.
5.
Select Send Email alarm linkage acon.
Trigger Alarm Output
The alarm output can be triggered by the normal and smart events.
Steps
1.
Go to Linkage Acon interface of the alarm input or event detecon.
2.
Click Trigger Alarm Output.
3.
Select the alarm outputs to trigger.
4.
Go to
Conguraon → System → Event → Normal Event → Alarm Output .
5.
Select an alarm output item from the list. Refer to Alarm Outpuor the alarm output sengs.
Congure
PTZ Linkage
Video recorder can trigger the PTZ acons (e.g., call preset/patrol/paern) when the alarm event,
or VCA detecon events occur.
Steps
1.
Go to Linkage Acon interface of the alarm input or VCA detecon.
2.
Select PTZ Linkage.
3.
Select the camera to perform the PTZ acons.
4.
Select the preset/patrol/paern No. to call when the alarm events occur.
Network Video Recorder User Manual
71