User Manual of Network Video Recorder
13
1.3 Starting and Shutting Down Your NVR
Power On
If the power LED indicator on the front panel is off, please check if the power supply is plugged into an electrical
outlet and the power switch is turned on; the LED should turn red, indicating the unit is receiving power.
When the LED is red, please press the Power button on the front panel. The Power indicator will turn blue. The
unit will begin to start.
Note: When the Ready indicator turns blue, the device is powered on and works properly.
Power Off
Standard Shutdown
Press and hold the POWER button for 3 seconds, and the device will enter power-off process. When the Power
LED turns red, turn off the power switch on the rear panel.
Other Methods of Shutdown
• Shutdown with Power Switch
Please try to avoid shutting down the unit by turning off the power switch on the back panel (especially
during recording).
• Shutdown by Unplugging Power Supply
Please try to avoid shutting down the unit by unplugging power supply (especially during recording).
Note: It is highly recommended that an Uninterruptible Power Supply (UPS) be used in conjunction with the unit.
To Next Page
Loading...
Need help?
General
