User Manual of Network Video Recorder
45
8.1 Configuring Alarm Input
Steps:
1. Enter Alarm Input Settings interface:
Configuration> Remote Configuration> Alarm Settings> Alarm Input
Figure 8. 1 Alarm Input Settings
2. Select the alarm input number and alarm type, “NO” or “NC”.
Note: “NO” is the default type. The settings will become effective after rebooting.
If you are using IP camera that is not from our manufacturer, please set this function by using its own
software.
3. Check the checkbox of Enable to enable the alarm input channel.
4. Set arming schedule.
steps:
(1) Click Arming Schedule tab to enter arm schedule settings interface.
(2) Click Edit button to set recording schedule.
To Next Page
Loading...
