User Manual of Network Video Recorder
86
11.3 Repairing Logical Disk
Purpose:
When the disk cannot display in the HDD Information interface while the logical disk can still show in the Array
Settings interface, you have to repair the logical disk.
Note: If the logical disk is in foreground initialization status, the repairing cannot be done.
Steps:
1. Enter the Logical Disk interface.
Device Management> Remote Management> HDD >Array Configuration > Logical Disk
Figure 11. 18 Logical Disk Interface
2. Click the Repair button to repair the logical disk. After successfully repairing, there will be note on the
lower-right side.
Figure 11. 19 Repairing Logical Disk Successfully
3. The disk shows again in the HDD Information interface (Device Management> Remote Management>
HDD).
To Next Page
Loading...
