Hill-Rom Basic Care Bed - Chapter 2: Troubleshooting Procedures; Getting Started

2
Hill-Rom® Basic Care™ Bed, Hill-Rom® 305 Manual Bed, Page 2 - 1
Hill-Rom® 405 Electric Bed Service Manual (MAN336 REV 2)
Chapter 2
Troubleshooting Procedures
Getting Started
WARNING:
Only facility-approved personnel should service the bed. Service by not
approved persons could cause injury or equipment damage.
Begin each procedure in this chapter with step 1. Follow the sequence outlined
(each step assumes the previous step has been done). In each step, the normal
operation of the product can be answered with a Ye s or No to the statement.
Your response will lead to another step in the procedure, a repair analysis
procedure (RAP), or a component replacement. If more than one component is
listed, replace them in the order given.
To begin gathering data about the problem, start with Initial Actions.
Do the Function Checks to isolate or identify a problem and to make sure the
repair (replace or adjust a part, seat a connector, etc.) corrected the problem.
Do the Final Actions after the Function Checks to make sure the repair
corrected the problem.
If troubleshooting procedures do not isolate the problem, call Hill-Rom
Technical Support at 800-445-3720 (USA).