*2155180*
2155180 日本語 13
Malfunction Possible cause Action to be taken
The fastening tool is hot and
doesn’t work even after a
break.
The fastener driving rate was well
above 1,200 fastenings per hour.
▶ Allow the fastening tool to cool
down.
No fastener is driven (or
driven only intermittently).
Ambient conditions are outside the
permissible range.
▶ Make sure that the permissible
ranges, in accordance with the
technical data, are observed.
The gas can temperature is outside
the permissible range.
▶ Make sure that the permissible
ranges, in accordance with the
technical data, are observed.
Gas bubbles have formed in the
gas regulating system.
▶ Remove the gas can and then
reinsert it.
The tool was not lifted completely
away from the surface after driving
a fastener.
▶ Lift the fastening tool completely
away from the working surface
after driving a fastener.
13 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
14 Manufacturer’s warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
オリジナル取扱説明書
1 取扱説明書について
1.1 本取扱説明書について
• ご使用前にこの取扱説明書をすべてお読みください。このことは、安全な作業と問題のない取扱いのた
めの前提条件となります。
• 本取扱説明書および製品に記載されている安全上の注意と警告表示に注意してください。
• 取扱説明書は常に製品とともに保管し、他の人が使用する場合には、製品と取扱説明書を一緒にお渡し
ください。
1.2 記号の説明
1.2.1 警告表示
警告表示は製品の取扱いにおける危険について警告するものです。以下の注意喚起語が使用されています：
危険
危険 ！
▶ この表記は、重傷あるいは死亡事故につながる危険性がある場合に注意を促すために使われます。
警告
警告 ！
▶ この表記は、重傷あるいは死亡事故につながる可能性がある場合に注意を促すために使われます。
To Next Page
Loading...
Need help?
General
