4 English 2155180
*2155180*
▶ Hold the setting tool only by the insulated grip when working in areas where fasteners may be driven
inadvertently into concealed electric cables. Contact with a live electric cable may cause metal parts of
the tool also to become live, leading to a risk of electric shock.
Instructions for handling the propellant gas
▶ Observe the instructions printed on the gas can and in the accompanying information.
▶ Escaping gas is harmful to the lungs, skin and eyes. Keep your face and eyes away from the gas can
compartment for up to about 10 seconds after removing the gas can.
▶ Do not operate the gas can valve manually.
▶ If a person has inhaled gas, take the person into the open air or into a well-ventilated area and place the
person in a comfortable position. Consult a doctor if necessary.
▶ Call a doctor if the person is unconscious. Bring the person into a well-ventilated area and place the
person in the stable recovery position (i.e. lying on the side). If the person is not breathing, administer
artificial respiration and, if necessary, supply oxygen.
▶ After eye contact with gas, rinse the open eyes thoroughly under running water for several minutes.
▶ After skin contact with gas, wash the contact area carefully with soap and warm water. Subsequently
apply a skin cream.
General instructions concerning personal safety
▶ Take care to adopt an ergonomic body position. Work from a safe stance and take care to stay in balance
at all times. This will allow you to control the setting tool better, even in unexpected situations.
▶ Keep other people away from the working area, especially children.
3 Description
3.1 Overview of the product 1
@
Fastener guide
;
RESET button
=
Inlet/outlet valve
%
Cooling air slots
&
Belt hook
(
Trigger
)
Grip
+
Nail pusher
§
Magazine lockbutton
/
Support leg
:
Magazine
∙
Type identification plate
$
Gas can status indicator
£
GAS button
|
Gas can compartment
¡
Gas can compartment cover
3.2 Intended use
The product described is a gas-actuated fastening tool (“fastening tool”). It is designed to drive suitable
fasteners into concrete, steel, sand-lime block, concrete-block masonry, rendered masonry and other
materials suitable for use of the direct fastening technique.
To Next Page
Loading...
Need help?
General
