Why doesn't the battery engage with a double click on my Hilti SCM 22-A?
If the battery does not engage with an audible "double click" on your Hilti Saw, it could be because the retaining lugs on the battery are dirty. Clean the retaining lugs and refit the battery.
How to unlock the on/off button on my Hilti SCM 22-A Saw?
Press the safety lock.
Why does the battery on my Hilti Saw run down quickly?
If the battery on your Hilti Saw runs down more quickly than usual, it could be due to very low ambient temperature. Allow the battery to warm up slowly to room temperature.
Why does the running speed of my Hilti Saw suddenly drop?
If the running speed of your Hilti Saw suddenly drops considerably, it could be because the saw blade jams. Do not tilt the saw blade.
What does it mean when 1 LED blinks on my Hilti Saw?
If 1 LED is blinking on your Hilti Saw, it could mean that the battery is discharged. Replace the battery and charge the empty one. It could also indicate that the battery is too hot or too cold. Bring the battery to the recommended working temperature.
Why does the saw blade stall on my Hilti SCM 22-A Saw?
The saw blade stalls because the saw advance pressure is too high. Reduce advance pressure and switch the product back on.
What to do if 4 LEDs blink on my Hilti SCM 22-A Saw?
If 4 LEDs are blinking on your Hilti Saw, it could be because the circular saw was overloaded briefly. Release the control switch and then press it again. Alternatively, the overheating prevention cut-out may have been activated. Allow the circular saw to cool down and clean the air vents.
How to fix Hilti SCM 22-A if chips fall onto the base plate?
If chips or cuttings from your Hilti Saw are not being transported into the chip collector and are falling onto the base plate, it could be because: * The chip collector is full. Empty the chip collector. * The chip ejector channel is blocked. Clean the chip ejector channel.
Why the LEDs on my Hilti Saw indicate nothing?
If the LEDs on your Hilti Saw aren't lighting up, it could be due to the following reasons: * The battery is not fully inserted. Push the battery in until it engages with a double click. * The battery is discharged. Replace the battery and charge the empty one.
Covers work area, electrical, and personal safety precautions for power tools.
Specific safety guidelines for cutting procedures, kickback, and guard function.
Provides personal safety, electrical safety, and battery handling safety advice.
Specific safety recommendations for operating circular saws, including blade use.
Specifies the product's purpose and limitations, including material and battery compatibility.
Provides specifications for the circular saw, including weight, dimensions, and operating limits.
Instructions for safely detaching the saw blade from the tool.
Step-by-step guide on how to safely install a saw blade onto the tool.
Guidance on how to make straight cuts accurately on the workpiece.
Lists malfunctions, possible causes, and actions to take when the saw is not working.
Lists common issues and their solutions when the saw is operating.
To Next Page
General
