Appendix X-AI 32 02
Page 56 of 60 HI 801 055 E Rev. 4.00
Index of Figures
Figure 1: Sample Type Label 11
Figure 2: Block Diagram 12
Figure 3: Indicators 13
Figure 4: Views 16
Figure 5: Coding Example 19
Figure 6: Connector Boards with Screw Terminals 20
Figure 7: Connector Boards with Cable Plug 23
Figure 8: Connector Board with Cable Plug, Variant X-CB 008 05 25
Figure 9: System Cable 27
Figure 10: Inserting the Connector Board 30
Figure 11: Securing the Connector Board with Captive Screws 31
Figure 12: Mounting and Removing a Module 33
Figure 13: Single-Channel Connection of a Passive Two-Wire Transmitter 42
Figure 14: Single-Channel Connection of an Active Two-Wire Transmitter 42
Figure 15: Redundant Connection of a Passive Two-Wire Transmitter 43
Figure 16: Redundant Connection of an Active Two-Wire Transmitter 44
Figure 17: Connection via Field Termination Assembly 45
Figure 18: Redundant Connection via Two Base Plates 46
Figure 19: Single-Channel Transmitter Connection with Barrier 47
Figure 20: Single-Channel Connection of One Analog Power Supply Isolator 47
Figure 21: HART Handheld in Parallel to the Transmitter and Input Module 48
To Next Page
Loading...
