xiv
―――――――――――――――――――――――――――
Attentions During Use
――――――――――――――――――――――――
NOTE
･
Due to the offset peculiar to elements from a hall
effect, the display may sometimes not show 0
immediately after it is turned on, but this is not a
malfunction. The count remaining has an
instrumental difference of 0 to a few A.
･
When using in DC or AC/DC mode, press the
0ADJ/RESET key each time the power is turned
on to carry out auto zero adjustment.
When 0 is displayed after zero adjustment, the
measurement can be performed without the
interference of the count remaining immediately
after the power is turned on.
To Next Page
Loading...
