Hioki 3284 - Attentions During Use

ix
―――――――――――――――――――――――――――
Attentions During Use
――――――――――――――――――――――――
DANGER
･ Use clamp testers only on power lines up to 600
Vrms, to avoid short-circuits and accidents that
could result in injury or death.
･ Always connect the clamp sensor to the
secondary side of a breaker. On the secondary
side of a breaker, even if the lines are shorted the
breaker can trip and prevent an accident. On the
primary side, however, the current capacity may
be large, and in the event of a short-circuits there
may be a serious accident.
･ When using an AC adapter, use only the
specified HIOKI model 9445-02 or 9445-03 (for
EU).
WARNING
･ To avoid electric shock, do not allow the
product to get wet, and do not use it when your
hands are wet.
･ To avoid electric shock when measuring live lines,
wear appropriate protective gear, such as insulated
rubber gloves, boots and a safety helmet.
･ During current measurement, to avoid an
electric shock accident, do not connect the test
leads to the product.
Attentions During Use
In order to ensure safe operation and to obtain maximum
performance from the unit, observe the cautions listed below.