37
―――――――――――――――――――――――――――
Chapter 2 Measurement Procedure
――――――――――――――――――――――――
MAX→MIN→AVE→Instantaneous value
(no annunciator)
2.8 Recording Function REC
Use the recording function to hold the maximum
and minimum measured values and
maximum/minimum averages.
1. Measurement indicated value
Pressing the
MAX/MIN
key during measurements of
current or voltage activates the recording function.
REC flashes and the product saves the maximum
value (MAX), minimum value (MIN), and average
value (AVE) in internal memory from the instant
you press the
MAX/MIN
key. Pressing the
MAX/MIN
key with the recording function activated
switches the display as shown below. If MAX,
MIN, or AVE is not displayed, an instantaneous
value is assumed.
Data (MAX, MIN, AVE) remains displayed while
the display is switched. If maximum or minimum
data is updated in the meantime, however, the data
values will change.
With the recording function activated, the auto
power-off function remains disabled. (APS off.)
The average value (AVE) displayed is calculated by:
Average Value = [(Maximum value + Minimum
Value)/2].
If the recording function is activated and
Instantaneous value (no annunciator) selected after
you activate PEAK mode with the
SLOW/PEAK/Hz
key, you can see the fluctuation of the peak.
2. Display of Elapsed Time
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
