41
―――――――――――――――――――――――――――
Chapter 2 Measurement Procedure
――――――――――――――――――――――――
2.10 Battery Low Warning
2.11 Beep Tone
･ When this indication appears, the battery is depleted,
which can lead to inaccurate measurements. Replace
the battery to ensure accuracy.
･ To check remaining battery life, check the bar graph,
when powering on or by pressing
OUTPUT
.The
bar graph provides a rough approximation of
remaining battery life. Be careful for the battery life
especially before using an output function for a long
term or when using the REC function.
･ Batteries tend to increase in voltage somewhat when
left unused for a long period. Even if the battery
warning annunciator becomes temporarily off after
the period, replace the battery as soon as possible.
If the battery is not replaced at this point in time,
the annunciator may not light up immediately on the
next occasion. Replace a new battery before it ruins
a measurement or causes some other inconvenience.
(See Chapter 4: Battery replacement)
To disable the beep tone, hold
RANGE
when
turning the unit on by pressing
POWER
.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
