Hioki DT4256 - Alarm Display and Battery Indicator

23
Alarm Display and Battery Indicator
1.4 Alarm Display and Battery Indicator
When the measured value exceeds the maximum input
range in each range
4.5 温度交互 2 4.5 画面 1 4.5 画面 2 1.4 の 1
1.4 の２ 1.4 の３ 2.1 3.1 の 1
3.2 の 2、交流電圧、
自動判別（左）、3.3
3.2 直流電圧 自動判別（右） 3.4 導通
3.5 OVER 3.5 ダイオード 3.6 抵抗 3.7 温度
3.8 静電容量 3.9 の DT4253 3.9 の DT4252 3.9 mA% 換算
3.10 3.11 4.1 オートレンジ 4.1
マニュアルレン
ジ
Voltage/Current measurement
The measured value and OVER blink and the red
LED lights up.
4.5 温度交互 2 4.5 画面 1 4.5 画面 2 1.4 の 1
1.4 の２ 1.4 の３ 2.1 3.1 の 1
3.2 の 2、交流電圧、
自動判別（左）、3.3
3.2 直流電圧 自動判別（右） 3.4 導通
3.5 OVER 3.5 ダイオード 3.6 抵抗 3.7 温度
3.8 静電容量 3.9 の DT4253 3.9 の DT4252 3.9 mA% 換算
3.10 3.11 4.1 オートレンジ 4.1
マニュアルレン
ジ
Measurement other than voltage and current
The measured value and OVER blink.
Corrective action:
When the input exceeds the maximum rating,
immediately move the test leads away from the
measurement object.
When the thermocouple is broken
(Temperature measurement) Thermocouple (K)
Corrective action:
Check that the thermocouple has been connected
correctly to the measurement terminal. If the display
does not change, Thermocouple (K) is broken.
Replace with a new Thermocouple (K).
Battery warning indicator
Fully charged.
As the battery charge diminishes, black charge bars disappear,
one by one, from the left of the battery indicator.
The battery voltage is low. Replace the batteries as soon as
possible.
(Blinks) The battery is exhausted. Replace the batteries.
The charge is only a reference for the continuous operation time.