Hioki DT4256 - Checking the Maximum;Minimum;Average

66
Checking the Maximum/Minimum/Average
4.4 Checking the Maximum/Minimum/
Average
The maximum value (MAX), minimum value (MIN), and average
value (AVG) of the measured value can be checked.
When the following measurement function is selected, this function
is disabled.
AUTO V, Electric charge detection
4.2 HOLD 4.3 FILTER 4.4 4.5 の１
4.5 の２ 4.5 の３ 4.9 APS OFF 4.9 ブザー OFF
4.9 ライト無効 4.9 調整元の確認 3.1 の３ヒューズ 4.4 通常に戻したい時
4.5 温度測定２ 4.5 ゼロコンデンサ 4.9 ADJ USER 4.3 FILTER OFF
## ## ## ##
## ## ## ##
Connect the test leads to the
measurement object and press
.
Each time the key is pressed, the main display
is changed.
[MAX]→[MIN]→[AVG]→[MAX]
The current measured value can be checked in
the sub display.
4.2 HOLD 4.3 FILTER 4.4 4.5 の１
4.5 の２ 4.5 の３ 4.9 APS OFF 4.9 ブザー OFF
4.9 ライト無効 4.9 調整元の確認 3.1 の３ヒューズ 4.4 通常に戻したい時
4.5 温度測定２ 4.5 ゼロコンデンサ 4.9 ADJ USER 4.3 FILTER OFF
## ## ## ##
## ## ## ##
Changing back to the normal display
Press
for at least 1 second.
• The maximum (MAX) and minimum (MIN) values are for the
displayed value; they do not relate to peak values such as AC
signals.
• When the
key is pressed and the instrument enters the
display mode for maximum, minimum, and average values,
the display of auto power save (APS) disappears and the APS
setting is canceled.