Hioki DT4256 - Communicating with PC

72
Communicating with PC
4.9 Communicating with PC
Using the optional DT4900-01 Communication Package, it is
possible to transmit data to the PC or to control the instrument.
Install the special software on the PC.
(See the Instruction Manual which accompanies with the
communication package.)
Attaching the USB cable to the instrument (p. 73)
Connect to the PC.
The virtual COM ports of the PC can be used as the USB interface. The
instrument recognizes the COM1 to COM256 virtual ports.
• Communication method: Start-stop system, half-duplex transmission
• Baud rate: 9,600 bps xed • Parity: None
• Data bit length: 8 bits • Delimiter: CR+LF
• Stop bit: 1 bit
Controls the
instrument.
Transmits data.