54
Cautions and Tips for Measurement
How to insert / pull out auxiliary earthing rod
How to Insert
The accessory auxiliary earthing rods are suitable for providing
auxiliary earthing electrodes and are designed for thickness and
hardness that allow insertion into a general ground by hand. Since it
is skinnier than conventional models, it can be inserted into a small
gap.
When inserting the rod, wear gloves and insert it perpendicular to
the ground surface.
If the ground is too hard for inserting by hand, use a hammer to
perpendicularly drive into the ground. Hammering the auxiliary
earthing rod too hard may result in bending it. In case of not going
into the ground with gentle taps, use the optional 9050 earth net for
measurement.
To Next Page
Loading...
