Hioki PW3337-01 - Connecting the Cable to the GP-IB Connector

4.4 GP-IB Interface Settings and Connection (Before Using Command Communications)
132
Specifications
GP-IB
Code used: ASCII code
Connecting the cable to the GP-IB connector
Connect the GP-IB cable to the GP-IB connector.
Recommended cable: Model 9151-02 GP-IB connection cable (2 m)
SH1 Supports all source handshake functions.
AH1 Supports all acceptor handshake functions.
T6 Supports standard talker functions.Supports serial poll functions.Talk only mode is not supported.Supports
the talker cancel function by MLA (My Listen Address).
L4 Supports standard listener functions.Listener only mode is not supported.Supports the listener cancel func-
tion by MTA (My Talk Address).
SR1 Supports all service request functions.
RL1 Supports all remote/local functions.
PP0 Parallel poll functions are not supported.
DC1 Supports all device clear functions.
DT1 Supports all device trigger functions.
C0 Controller functions are not supported.