Hioki PW3337-01 - Starting Integration; Stopping Integration

3.3 Integration
64
Display method
Method for starting and stopping integration and resetting integrated values
The following four methods are used to start and stop integration and reset integrated values:
• Using
• Using communications (see the Communications Command Instruction Manual)
• Using external control (p.85)
• Using synchronized control (p.81)
This section describes use of .
For more information about integration using communications, external control, or synchronized control, refer
to each section indicated above.
Starting integration
Stopping integration
Press through to select the display parameter.
See: "3.2.3 Selecting Display Content" (p.44)
1 Verify that the instrument is in the
integration reset state (RUN and
EXT lamps off).
2 Press .
3 Integration will start, and the RUN
lamp will light up.
1 Press while the RUN lamp is
lit up (indicating that the instrument
is performing integration).
2 Integration will stop, and the RUN
lamp will flash.