28
Installation GRS1020/1120/1030/1130
Release
03
01/2017
To change to the LED display on the service panel, execute the following
commands in the CLI:
1.7.3 Media module status
1 LED is located on the media module at the bottom left.
This LED provides information on the supply voltage status of the media
module.
enable Change to the privileged EXEC mode.
configure Change to the configuration mode.
system port-led-mode
servicepanel
Change LED display from port panel to service
panel.
LED Display Color Activity Meaning
Power Supply voltage — None Media module is inoperative
Green Lights up Supply voltage is on
To Next Page
Loading...
