44
Installation GRS1020/1120/1030/1130
Release
03
01/2017
6 Disassembly
6.1 Removing the device
Proceed as follows:
To detach the device from the switch cabinet or the wall, remove the
screws from the brackets on the device.
6.2 Removing an SFP transceiver (optional)
Proceed as follows:
Pull the SFP transceiver out of the slot by means of the opened lock.
Close the SFP transceiver with the protective cap.
WARNING
ELECTRIC SHOCK
Disconnect the grounding only after disconnecting all other cables.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
To Next Page
Loading...
