Installation GRS1020/1120/1030/1130
Release
03
01/2017
35
Grounding the device
The device variants have a connection for protective grounding.
This applies to device variants with a supply voltage with the
characteristic value M:
The device is grounded via the ground screw and also via the power
supply socket.
See figure 6 on page 37.
Ground the device via the ground screw.
2.3 Installing an SFP transceiver (optional)
Remove the protection cap from the SFP transceiver.
Push the SFP transceiver with the lock closed into the slot until it latches
in.
Figure 4: F/O SFP transceiver
Use only Hirschmann SFP transceivers which are suitable for usage with the
device.
See “Accessories” on page 54.
To Next Page
Loading...
