34
Installation GRS1020/1120/1030/1130
Release
03
01/2017
Mounting on a vertical flat surface
Use the pre-mounted brackets as shown below.
Additionally attach 2 brackets to the back of the device.
You obtain the additional brackets as accessories.
See “Accessories” on page 54.
Fasten the device by screwing the brackets to the wall.
Figure 3: Mounting on a vertical flat surface
WARNING
FIRE HAZARD
Install the device in a fire protected shell if you are mounting it vertically.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
To Next Page
Loading...
